-
Hello.
Trying use part of your code (btw, great thanks to you) with input source of 32V.
The problem is: xy.setCV() is working properly, only up to some value (1200 - 12V).
But **if I'm using b…
-
Does anybody have a good solution to power this module from 12V (car)?
-
The 12V line doesn’t get cut when the GPIO pins are connected to the thruster board. I believe the e-stop drain is getting connected to GND through the Jetson GPIO pins.
-
-
I am afraid ±12V is not as expendable as I initially supposed. We had a fruitful discussion in the Retrocacharreo channel in Telegram about the topic. And many hardware for sound and video processing …
-
-
I've had reports of high 12V drain from a Kia e-niro owner running latest edge build.
Possibly the car is being kept aware? The drain rate seems to be higher than just the OVMS module. It's unclea…
-
Hello, I have a 12V/2A power adapter and if I use that as VCC input, the board is getting warm after ~30 mins, and the ESP does not respond.
Do you have a suggestion what can be wrong?
-
This programmer https://www.tindie.com/products/leonerd/avr-updi-programmer-with-12v/ is implementing a 12V HV enable pulse, by RTS handshaking line being asserted when the serial port is opened.
But…
-
tying both together to the single 12v raw pin it has