-
Is there a way to send data to an Influx 2.0 database? There is a new auth process that uses a token instead of username and password. I have not found a solution in the current software for authoriza…
9lstr updated
5 months ago
-
1. I do not have a SDS011 installed on my 2nd ESP8266.
It is also not activated in the configuration page.
However I see the values "samples", "max_micro" & "min_mirco" in my influx database.
…
-
The ESP32 example compiled fine for ESP32 boards, at least in my environment of the Ardoino libraries and IDE.
The SDS011_example would not compile for any ESP8266 board I tested.
> Arduino: 1.8…
-
Hello everybody,
i built my Airrohr last friday, i discoverd that my BMP280 was reporting a rather low tempratur of -140.12°C. The presure had an reasonable value. So i started investigation with a…
-
Hi,
how does the sleep and wakeup command shall be used?
thanks for reply
-
Das Projekt wird größer und immer wieder tauchen Fragen zum Anschluss von Sensoren und Displays an.
Nicht immer ist alles aktuell und an einem Ort dokumentiert.
Ich sehe da Verbesserungsbedarf.
…
-
Habe einen SPS30 Feinstaubsensor hier und einen NodeMCU V2.
Angeschlossen ist er wie hier empfohlen :
Pinout: 1 2 3 4 5
Pin 1 (5V) -> Pin VU/VIN
Pin 2 (SDA) -> Pin D3 (GPIO0)
Pin …
-
Hello,
Thank a lot for that code.
I need to make it working with Python3 but it generate this error message
> File "aqi.py", line 130, in
> cmd_set_sleep(0)
> File "aqi.py", line 104, in cmd_s…
-
This morning I noticed that my sensor didn't send data anymore to madavi. I could see it was still connected to the wifi/router but I couldn't connected to its IP.
When I used the serial monitor to…
-
Wenn ein ESP ersetzt werden muß (zum Beispiel weil die USB-Buchse defekt ist) hat man keine gute Möglichkeit mehr, die bestehende Meßstation weiterzuführen. Die neue ESP reportet dann mit ihrer esp_id…