-
**First of all I want to thank everyone for the support and positive reactions we got on the 5 beta release of the community firmware. All the testing and feedback has made this firmware better and be…
-
__Issues that do not follow this issue template will be closed__
### Description
I upgraded my CR-6 SE to community firmware release 5 last week. I later flashed klipper to give it a go.
…
sjdrc updated
3 years ago
-
First of all I want to thank everyone who has been [testing the alpha 4 release of the community firmware](https://github.com/CR6Community/Marlin/releases/tag/v2.0.7.1-cr6-community-release-4-alpha). …
-
### Description
After upgrading to the newest Release (6.0) and using the PID-Tuning function for the first time, my prints constantly fail because of a thermal runaway error. At first I thought th…
-
### Description
I have confirmed by testing that CF6 Final does not prevent users from specifying nozzle temperatures higher than MAXTEMP-HOTEND_OVERSHOOT.
I can not test whether it protects aga…
-
### Description
After flashing the new CF6 Pre 3 and reseted my printer to factory settings I noticed that I can't change the E-Step value to my known good value directly on the printer without the…
-
As the UI becomes enhanced with new configuration functions like esteps, PID, Retract/Restore, etc.., Users who do not use their USB serial interfaces are going to have increasing need to be able to s…
-
### Description
Homing is done with a nozzle temp of 120° and the bed temp from the G-Code (in my Case 80°). After Homing the line on the left side is "printed" with 120° nozzle temp. Then it heats…
-
Please note I reported this bug in the Pruca forums, didn't see the report here at github until after I posted(Nigel) sorry about that.
### Version
_Version of PrusaSlicer 2.3.1RC_
### Operatin…
-
## 0. Setup
I've tested most values below. Not all testings are shown in this report. I only included the testings that are showing errors/warnings or inconsistent results.
```r
cluster_gen_2