-
```
What steps will reproduce the problem?
1. Trying to issue an 'ND' command (API mode) and later parsing it (the problem
is in the parsing).
For example:
xbee.send("at", frame='A', command='N…
-
Using the aws_publish example with umqtt installed on XBC KTE-M/NB-IoT modem firmware 11415 with L0.0.00.00.05.08 installed. When I run the example I get:
File "", line 58, in
File "", line 47, …
-
Hi, I'm fairly new to Kotlin and Android so this might end up being a silly mistake.
I'm trying to design an app which will connect to two XBee3 modules at once via Bluetooth and continuously recei…
-
Hi Everyone,
Currently, I am working on my university project were, we have to transfer an image via Zigbee XBee Module S2C.
So, I am trying to use the Xmodem (https://xbplib.readthedocs.io/en/lat…
-
```
What steps will reproduce the problem?
1. Trying to issue an 'ND' command (API mode) and later parsing it (the problem
is in the parsing).
For example:
xbee.send("at", frame='A', command='N…
-
Dear Andrew,
does your Arduino - XBee API mode library support the use of the Explicit Addressing ZigBee Command frame?
Thanks in advance,
Regards,
Dario
-
# Discussion and notes about the future logger
## Design of the future board
### Components to include, and Architecture
![image](https://raw.githubusercontent.com/spectraphilic/wsn_hardware/ma…
-
```
What steps will reproduce the problem?
1. Trying to issue an 'ND' command (API mode) and later parsing it (the problem
is in the parsing).
For example:
xbee.send("at", frame='A', command='N…
-
Changing the value of a Pin with the pin method is extremely slow. It takes about 2.5 ms (!) to change the pin output level. A 0/1 burst then has a frequency of 200 Hz.
Other micropython port are in …
-
Hi. This is a great project to boostup IOIO feature list and appreciate your efforts on open source. I have few queries before I would like to give a try. Due to my heavy work load I was struggling to…