-
I followed the steps shown [here](https://gobot.io/documentation/platforms/arduino/#ubuntu) and I got the following error.
![Error](https://i.imgur.com/6ujAavg.png)
Maybe I did something wrong, bu…
-
### What happened?
Hello,
I have a question rather than a bug report.
Is it possible to compile plc4j-apache-kafka with newer versions of the OPC-UA and S7 drivers? If so, is there any document…
-
### Is your feature request related to a problem? Please describe
In some use cases all the GPIO pins on a RPi are being utilized and additional pins are needed for power control. In my specific cas…
-
```
What change would like to see?
TwoWire.end() function that disables I2C and returns both pins to normal
operation.
Why?
So the pins can be reused
Would this cause any incompatibilities with p…
-
```
What change would like to see?
TwoWire.end() function that disables I2C and returns both pins to normal
operation.
Why?
So the pins can be reused
Would this cause any incompatibilities with p…
-
```
What change would like to see?
TwoWire.end() function that disables I2C and returns both pins to normal
operation.
Why?
So the pins can be reused
Would this cause any incompatibilities with p…
-
```
Hi,
I can't communicate with my Arduino (Duemilanove, ATmega168) with
Firmata under Linux (Arch Linux 64 bit).
I tested both "stock" Firmata that comes with Arduino IDE and
Firmata-2.1beta7.zip d…
-
Here's my setup:
- Mac (v10.8.2)
- Arduino Leonardo with Firmata 2.3.2 (tried with 2.3.3, 2.3.4 and 2.3.5 too)
**NOTE**: I tried to downgrade to 2.2 (as suggested in the README file) but the Arduino …
-
The "move complete command" in AccelStepper lists value 0x0b in
protocol/accelStepperFirmata.md . However, the implementations use 0x0a:
https://github.com/firmata/firmata.js/blob/488964da379b13…
-
Szenario to be addressed:
Arduino is connected by other means than serial and connection drops and reconnects. There's no way to know whether firmata did reset while being disconnected. To ensure sync…