-
I'm planning to use a Sonoff Basic to power up a rotating disco ball and light when a button is pressed. I was planning to have a GPIO pin on the ESP8266 trigger an arduino to send serial commands to …
-
Sometimes when I send a command with my remote control, the gateway does not receive what I expect.
Instead, the code "5471" is received.
I don't suppose this is a reception problem.
Anybody el…
-
**Home Assistant release (`hass --version`):**
0.42.2
**Python release (`python3 --version`):**
Python 3.4.2
**Component/platform:**
RFlink/HASS running on RPi3/latest Raspbian
**Descripti…
-
Make sure you are running the latest version of Home Assistant before reporting an issue.
You should only file an issue if you found a bug. Feature and enhancement requests should go in [the Featur…
-
Hello,
I'm trying to control a 433MHz outlet with this library, but it seems that setting the pulseLength doesn't work.
I'm using an Arduino UNO R3 and a FS1000A sending module.
The original …
quaec updated
7 years ago
-
I've been attempting to use the gateway with an Arduino Duemilanove using a 433mhz RF transmitter/receiver, yet have been having quite a fair amount of difficulty in getting it to work. It seems that …
-
my installation it is very extensive. I'm about to try using PJON as protocol, but using rs485 like interface.
Analyzing the code I see very optimal to send commands as I need.
I'm trying to control r…
-
Using PJON 3.0 beta as of 2016-05-13.
To me it seems that sending messages in both directions like this works over a wire but not wirelessly.
Having set up two Arduino Unos with a wireless sender+re…
-
```
Welke stappen leiden tot de fout:
De hardware waarmede getest werd bestond uit:
- Kaku zender TMT-502
- Arduino Mega 2560 + ethernet card + SD card + ontvanger XY-MK-5v en zender
FS1000A
- Er we…