-
A few additional features would make this an amazing All in one Air Handler monitoring device:
1. 1-wire interface to connect DS18B20, DHT22, and other Temperature and/or Humidity sensors.
2. Opto…
-
-
Hallo,
ich muss nochmal das Thema Eingänge hervorkramen.
Ich kontrolliere sehr viele Ein-/und Ausgänge des Raspis4 seit vielen Jahren mit dem rpi2 Adapter ver.1.3.2. Seit dem Update auf die Versio…
-
### Is your feature request related to a problem?
I need the ability to read the GPIO holder status per pin, so that I can discover the state of different peripherals after a restart.
### Describe t…
-
### **Issue:**
I2C Scan on ESP32-S3 Returns No Devices
### **Description:**
I am trying to scan for I2C devices on the ESP32-S3 using MicroPython but getting no devices detected, even though the…
-
### Hi there !
i tryed myself but only get blank white screens
i think for some dev in here it's a few minutes to fix.
*some more info :*
*from smartdisplay-demo :*
"build": {
"ardui…
-
Hi,
after upgrading my APU2 from Debian 10 (Kernel 4.19) to Debian 11 (Kernel 5.10) I'm getting a couple of these error messages at boot time:
`kernel: gpio-keys-polled gpio-keys-polled: unable to…
-
Hello,
I am using 3.5" TFT LCD Shield with Arduino Uno and its work great, but in other project i can't…
-
```
[12ms] Platform: ZuluSCSI Pico
[12ms] FW Version: 24.10.16-release Oct 16 2024 17:34:59
[12ms] DIP switch settings: debug log 0, termination 1
[12ms] SCSI termination is enabled
[12ms] Flash …
-
my HW esp8266 use sht30 via i2c on:
sda gpio0
scl gpio2
and SDS011 soldered to
sds tx-esp gpio5
sds rx-esp gpio4
if i choose this GPIOs in configuration sensor never began to run.
![bug1](…