-
What is the overarching design guidance for the API? I'm guessing that much of the structure/organization has been informed by the makeup of Pentair's Intelli-whatever panel UI, but I'm also guessing …
-
**Describe the bug**
Connected Pentair Ultratemp Heat Pump via RS-485. When nsjPC sends command (i.e. I try to set the temp) the heat pump flips on the service light with an error "SERIAL COMM LOST"…
-
Ultratemp heater cooling mode not showing up. I have the Aquacal 166R which has heat mode and cooling mode. This is setup as an ultratemp in the intellicenter panel however, the pool controller dashbo…
-
**Describe the bug**
I have raspberry pi setup running poolController and dashPanel. It is connected to the IntelliChem via RS-485 serial to USB controller. I am getting no data. I have swapped the d…
-
**Pool Equipment**
- Controller: Nixie single body
- Controller Model:
- Controller Firmware Version:
- Pump(s) manufacturer and model: Pentair
- Chlorinator: AquaRite
- Heater(s): none
…
-
Not sure if this is a UI issue or a schedule issue. Or just isolated to my environment.
3 days a week, I run my pool at a higher RPM for an hour in the morning to let the in-floor cleaning swivel …
-
**Describe the bug**
A few steps here, let me try to explain what I have seen - and some of this may come back to config (vs. code), by all means yell if there are things I should try!
1) In pool m…
arrmo updated
3 years ago
-
Creating a new issue for tracking purposes.
I'm on v7 across the board now (njspc/dash/REM), but still seeing those phantom circuits I referenced below. If you need a fresh replay of the startup s…
-
Spillway circuit doesn't seem to be detected. I also have a schedule to run the spillway and this appears as "unnamed"
[replay.zip](https://github.com/tagyoureit/nodejs-poolController/fil…
-
[replay(1).zip](https://github.com/tagyoureit/nodejs-poolController/files/6057916/replay.1.zip)
Hi guys, I'm back! After this working for a while, it has now stopped. I was having trouble with…