-
# Bug Report
## What happened
I bought the following device for my living room: https://www.paul-neuhaus.de/shop/de/led-deckenleuchte-smart-home-design-modern-welle.html
The device paired as foll…
-
Hi,
Just picked up an old Zigbee Greenwave RA11D51-A11-GR
Seems to be manufactured 2013.
Based on TI CC2530.
I found a serial interface that outputs data on startup.
It does not parse any da…
-
Hi,
I bought Zigbee 3 candles from tint with RGB support and paired them with my hue bridge just fine.
I use homebridge-hue 0.11.2.
Switching the lights on and off using homekit works just fine, …
-
Running v2.05.40 with 0x26230500, but I think I saw the same symptoms on v2.05.39. deCONZ marks the Xiaomi Aqara curtain controller `lumi.curtain` as zombie (red node), even though it's still sending…
-
The ZCL spec states (in 2.5.8.1) that the ZCL payload of the _Configure Reporting Response_ command should contain a series of (_Status_, _Direction_, _Attribute Identifier_).
I found during sniffi…
-
Hi Guys,
Ik hope you can help me out. This evening I updated my Zigate firmware to the latest version 3.0e. Now when I permitted joining in domoticz for 254 seconds. The zigate is not recieving any…
-
Hello,
If I'm not wrong, I've updated to the latest beta following the instruction, which I think is compatible with the Aqara (Xiaomi) switches.
How should we add them in the webinterface? As a…
-
I fear there's something going wrong with the routing in 0x26240500. I'm seeing red nodes again, and my two innr RB 162 bulbs don't seem to receive any unicast messages. They do react to groupcast m…
-
@fairecasoimeme Is it possible to reset the device to the bootloader, without pressing the button?
There are Ftdi-Chip Serial board designs that put the Jennic chip into reset over the DTR/DSR lines.…
-
I've got a `lumi.ctrl_neutral2` switch (end device) which cannot be reached from deCONZ, even though it's active on the network. The switch seems stuck in a loop, where it requests the attributes of …