-
How to increase txpower on comfash 785ac to 30dbm
-
After solving #55 the PSU does not work anymore. I have to use "Pause" on Scope CH1 twice (Pause on, Pause off) in order to make the voltage setting for the PSU work again.
Also the Multimeter show…
-
On my new Astro, I've noticed pulsing noise over my headphone jack. It gets worse (louder) when I listen to music.
I didn't notice this yesterday when streaming via wifi (see https://github.com/shy…
-
First, not sure if RO or RP-0 is the right tracker for this, both are affected i guess, also there's #1965 but i thought a new issue for this proposal might be appropriate.
As i've been wanting to …
-
I have a WT32-ETH01 board connected to VS1053. I use these pins:
```
pin_vs_cs = 15 # GPIO Pin number for VS1053 "CS"
pin_vs_dcs = 4 …
-
Hi Tim,
Branching over from the Instructables page. I don't think there is anything wrong with the way you implemented the PDM software on two cores... I think it is a problem with the way I am assum…
-
@SimHacker [posted this](https://news.ycombinator.com/item?id=15080221):
> Zork is how and why I got on the ARPANET as a nerdy kid. And I wasn't even a [Russian Spy](https://www.youtube.com/watch?v…
-
Many years ago I built a module that could hotswitch between 3.3v and 5v going to the PA allowing me some control over the power output of the module, it basically involved a switch going between the …
-
I'm attempting to utilize rr on my VMWare Workstation 14 machine, however it appears that it does not expose the perf counter type that you expect. Specifically, I'm finding the following:
```
per…
-
I'm running a Hermes Lite 2 with pihpsdr, and there is a red "Sequence Error" displayed on the screen.
What is this for?
Charlie KB8CR