-
I recently installed a new MKS SGEN LPC1769 board in my 3d printer. I just installed a completely new source environment using an archive that was downloaded April 12 of Release v2.0.5.3. I edited t…
-
When I enable the option `CONFIG_STACK_CANARIES` is not running.
It builds correctly, I flash it to the board, but `main()` is never entered. Somehow this option breaks the build.
This is affect…
-
Hello,
According to a tutorial - https://youtu.be/LxQWCBE6lLk?t=441 - the SKR-E3-Turbo should have FAN1 header automatic on/off feature based on hotend temperature.
I have defined the extruder f…
-
hello guys
i need the PIN numbers for the AUX-1 pins. I will connect a PT100 to it
the red marked Pin numbers i need.
I found the other pictures on google. but it doesn't work
![FB_IMG_156275228…
-
Hi,
I was using SKR 1.4 turbo board with components above for 16 days without ant problem. However, suddenly heat sensors are broken, and the nozzle always is seen 104C, and the bed is -14C. Wheth…
-
I have mostly ported GRBL to the RT1020EVK board, which has an Arduino shield socket. The serial comms is working fine (using CDC usb) and I am about to test the stepper routine. I might have a few qu…
Moffy updated
4 years ago
-
This board is larger than the other SKR Mini E3 versions and interferes with the power supply in the Ender 5 electronics case.
-
I installed the BTT SKR 1.4 Turbo and have been able to print for a while. Recently the extruder would stop mid print. X, Y and Z would keep going and heating was kept on. After stopping print extrude…
-
Hi Scott,
would it be possible to add support for SKR E3 Turbo with little effort? It has the same LPC1769 as SKR 1.4 Turbo.
Im just not sure if it would be possible to wire it to rasberry pi:
ht…
-
# **A Treadmill to Rule Them All**
A famous soft drink factory is planning to build *Pepsicity* for its most devoted customers. To achieve this ambitious project, they've recruited the best team …