-
```
What steps will reproduce the problem?
1. Upload your Panel 2 settings to OSD
2. Enable OSD toggle channel
3. Toggle OSD channel through Tx
What is the expected output?
To see the Panel 2 settin…
-
```
What steps will reproduce the problem?
1. Upload your Panel 2 settings to OSD
2. Enable OSD toggle channel
3. Toggle OSD channel through Tx
What is the expected output?
To see the Panel 2 settin…
-
```
What steps will reproduce the problem?
1. Upload your Panel 2 settings to OSD
2. Enable OSD toggle channel
3. Toggle OSD channel through Tx
What is the expected output?
To see the Panel 2 settin…
-
```
What steps will reproduce the problem?
1. Upload your Panel 2 settings to OSD
2. Enable OSD toggle channel
3. Toggle OSD channel through Tx
What is the expected output?
To see the Panel 2 settin…
-
Until recently I was forced to deal with the not-remotely-great MakerMade Due controller that only accepts GRBL and doesn't work with GroundControl/WebControl. I've since gotten an original Maslow con…
-
In order to prevent damages to the z axis mechanism and motors, it would be useful to be able to set upper and lower limits for the movement of the z axis mecanism that are independent of the drill bi…
-
Hi,
In Makerverse 1.0.6 there was a CNCJS widget in the left hand column that allowed feed rate (and spindle speed if used) to be adjusted by 1% or 10%, or reset to programmed value, during cutting. …
-
I have a moderately complex home network. I connect my RPi to wifi but at some point the pi starts issuing IP addresses. My Pi-hole is what I want to issue my IP addresses. I think this is caused b…
-
```
What steps will reproduce the problem?
1.pyrit -r ~/Downloads/pyrit-0.4.0/test/wpapsk-linksys.dump.gz analyze
2.
3.
What is the expected output? What do you see instead?
Information about the tes…
-
```
What steps will reproduce the problem?
1.pyrit -r ~/Downloads/pyrit-0.4.0/test/wpapsk-linksys.dump.gz analyze
2.
3.
What is the expected output? What do you see instead?
Information about the tes…