-
### The problem
Every few days, the HA stops receiving data from the sensor. Prior to this, the sensor worked for more than a year without failures. At the same time, these data are visible in the as…
-
Hi, I ran the following command as written in the readme
git clone https://github.com/UedaTakeyuki/mh-z19.git
. /setup.sh
but when I do sudo python -m mh_z19, I get No such file or directory: ' /de…
-
Hello everybody,
I have some devices with the dust sensor PMS7003 and some with the SDS021.
The devices with the SDS021 run smoothly for weeks.
Those with the PMS7003 only make a few measurements…
-
I set up controllers
Protocol: Generic HTTP
Controller Publish: {"%vname1%":%val1%,"%vname2%":%val2%,"%vname3%":%val3%}
Send Interval: 30 seconds
As in the example above, if the values are 3, ES…
-
Hi,
I've cloned the most recent repo version and connected everything as shown in the Readme. However, it seems no value is received. This is my output and my connections:
```
sudo python -m mh_z19…
-
### The problem
I'm trying to use ESPHome on esp32s2 board to connect two uart sensor PMS7003 and MH-Z19, when using only one uart, both sensor works, when using two uart together, I can't get logs …
-
After flashing a file compiled using Custom.h, the access point does not appear, the STA mode is turned on.
If you compile the normal version, the access point works
I used esp8266
INIT : Boo…
-
Hello, thank for your library, it's very useful, especially Recovery and Calibrating part.
When i use SoftwareSerial, everything work great, but 3 hours later i don't receive any data from the sensor…
-
From yesterday, every 10 minutes I take measurements (NodeMCU + CCS811). In the code I have ```delay (300000);```. I send measurements to my InfluxDB database. I visualize them using Grafan. Here are …
-
### The problem
I'm using D1 Mini ESP32. I have 3 UARTs created, one for a SenseAir S8 CO2 sensor, another one for MH-Z19 CO2 sensor and the third one for a PMS7003 PM sensor.
If I remove in the…