-
Hi,
I have successfully built micronucleus for ATtiny44A with an external 12Mhz crystal clock using the following settings and flashed it to the MCU.
Makefile.inc
```
F_CPU = 12000000
DEVICE…
-
Please also have a look at discussions: https://github.com/micronucleus/micronucleus/discussions
**Describe the bug**
Setting FAST_EXIT_NO_USB_MS to any value different than 0 (even
-
I'm not sure if this is possible, but I was wondering if these usb dongles can be used as linux gpio pins via the libgpiod device manager.
So they can show up as:
`/dev/gpiochipN` where N is the c…
-
If it's not here, I don't know about it.
1. tiny841, 441, 828 ( the ones with neither hardware twi master nor a USI) are not recognized by wire. **Impact**: Wire.h does not work on affected device…
-
This has been superseded by #750. Optiboot in this state is unfit for purpose, Fixing it is hard, and urboot does it correctly uploads faster and uses less flash and best of all doesn't need to be wri…
-
# cat /var/log/socklog/cron/current | egrep -i "line |exited"
2023-11-02T22:01:01.55380 cron.info: Nov 2 19:01:01 CRONIE-CROND[24771]: (root) CMDOUT (/etc/cron.hourly/0anacron: line 11: /etc/def…
-
Digispark loses firmware
I have a problem with digispark board. Brief description:
My sketch controls the servo via button presses. Powering the circuit from the battery through the step-up module MT3…
-
Hello, I'm working on trying to do some code on my ATTINY85 and I have one line that is causing an error when ever I try to verify the code. Here is the code:
`#include "DigiKeyboard.h"`
And here is…
-
Reference: Input/output error when using libusb0.sys driver with libusb-1.0+libusb-compat-0.1, when using Micronucleus bootloader (avr FW based USB bootloader).
https://github.com/avrdudes/avrdude/is…
-
Based on comments in issue #707 "Interrupt pins on the Attiny88/MH-ET-Tiny88?", I created a minimal sketch demonstrating it works differently from what I expected.
Expected was a slow blinking of th…