-
I have a MMDVM_HS_DUAL with 12,880 MHz. With FW 1.5.2 all worked, if I compile the newest 1.6.0 MMDVMHost says NAK from modem. MMDVMCal also not working. Flashing backward to 1.5.2 bring all back, the…
-
I have several zumradio repeaters and after updating to the current firmware I'm left with mmdvm not recognising the modem anymore. After checking on the current MMDVMHost repo there's a newer releas…
-
Good morning all
Following a recent update of MMDVM I just lost the connection to the Brandmeister master.
The relay has since been in stand-alone mode and no longer makes it possible to receive and…
-
Hi, I'm using mmdvm repeater with nucleo-446re, two motorola radios, RPi4/2GB and everything works great . I have update the controller with new MMDVM FW, the MMDVMHost works but the latest version of…
-
Hi,
I find a bug here , I not suggest to lock the Duplex mode or Simplex mode by the $confHardware type ,because Duplex HS still need SIMPLEX mode , some time for test or just want to act as SIMPLEX …
-
Recently I got USB supported MMDVM_HS_Hat from AliExpress, and it is programmed USB-CDC capable firmware.
I build recent MMDVM_HS firmware and installed, OpenBSD (I don't know about other OSes) canno…
-
Hello,
I'm working to create a software to send/receive audio/messages using DMR protocol.
Currently I arrive to do the RX/demod using a uggly flow graph (GNU Radio flowgraph (verry uggly and CP…
-
all date weather it come in on TS1 or 2 go to TS 2
I have try below in the setting ini and nothing change.
still going to TS2
I would think its some were in the mmdvm change over
# 1 = only TS1,…
-
Hello
i use the MMDVM V3F4 from BI7JTA Winter.
Read out from Raspberry Pi MMDVM Modem Port to Display work perfectly.
Because detection of Display or sending commands from Display to Raspberry …
DL9AM updated
8 months ago
-
Hi
This is not a bug report, more of a question...
I have a 1.0 board, which basically works fine, but performs very badly, especially RX.TX/RX are 7.6 Mhz apart as usual in Europe on the 70cm b…