-
Hi,
I applied overlays to beaglebone black but cannot use RS485 overlay.
When I try to make MODBUS communication with UART4, the RTS pin cannot be set.
I can use usbtoRS485 converter and abl…
-
Currently I am facing the following problem:
I have 3 slaves with 3 IDs 1, 2, 3 connected to 1 modbus rtu COM port.
I don't know how to read and write data to 3 devices.
When using the follow…
-
hello I am trying to use this modbus ros driver to communicate with a communication protocol modbus rtu. I am not able to Start a modbus server using the command $ rosrun modbus_wrapper modbus_server.…
-
I tried the library with the esp8266 to communicate with the Epever charge controller and with a few adjustments I even managed to establish a connection. However, the connection was rarely stable. As…
-
### Steps to Reproduce
Change the parity under advance setup to any value other than NONE.
### Expected Result
Expected everything to continue to work.
### Actual Result
Once this change is mad…
-
### Related area
UART
### Hardware specification
UART
### Is your feature request related to a problem?
Currently ( with arduino v3 and idf v5 ) I can register callback functions for `o…
-
Is there any chance of getting support for easyControls 3.0?
I checked the communication using web browser, it seems to open webSocket connection and the communicates and delivers data using the webS…
-
Can I use this modbus ros driver to communicate with a communication protocol modbus rtu?
-
It sometimes reads the data sometime, it hangs to read from the bus and write to the Bus.
I get a lot of CRC error while reading and writing to Register.
I am continuously reading from a coil, that …
-
Hello everyone, I hope you are well. I have managed to successfully integrate the ModbusPal emulator with EdgeX Foundry's modbus microservice. However, I have doubts about integrating any device with …