-
https://github.com/TheSpaghettiDetective/moonraker-obico/blob/42d764e70b1c6279e1f0242348ee839894557a66/scripts/install_creality.sh#L33
Can you replace opkg commands in Creality K1 script by /opt/bi…
-
When running [OrcaSlicer](https://github.com/SoftFever/OrcaSlicer) on the `Device` tab, the webcam preview is just blank. Refer to [this](https://github.com/SoftFever/OrcaSlicer/issues/2927) issue for…
-
While doing this step: ./install.sh
I'm getting this:
Cache entry deserialization failed, entry ignored
Retrying (Retry(total=4, connect=None, read=None, redirect=None, status=None)) after conne…
-
Hi there!
Can some one help me? I'd install Obico API and client success. All in Docker, except the camera-streamer it run as systemctl daemon. Config of moonraker-obico has that configuration.
…
-
I use a Sonic pad with my ender 3 S1 Pro and spent the last two days trying to figure out how to get this installed on the Sonic Pad to no avail. Any advice to getting it to work so that I can get not…
-
I've followed the installation steps to install the companion onto my RPi hosted Klipper/Mainsail (fully updated versions), however now I am not able to load the webgui - I'm stuck on the webpage sayi…
-
Hello all,
I am attempting to install obico on my new Qidi X Max3, and have run into a problem with Step 4 of the Installation guide found at:
https://www.obico.io/blog/qidi-tech-x-series-klipp…
-
Hi there!
I had write an issue in moonraker-obico, but I think the problem is here. Help me pls 🥲
To avoid duplication, I will attach a link to the problem [#83](https://github.com/TheSpaghettiDe…
-
### What happened
If the printer has been shut down since a previous print, I cannot send a new print via Cura to Moonraker without "touching" a gcode file. If I view (I don't have to save/edit) the …
-
### What happened
Path error for configuration files & gcode files - even though I've updated them to reflect the "expected" path. Tried several iterations of the path to no avail!
### Client
Mains…