-
**The Idea:**
- The downstairs workshop is quite messy and has a lot of old / unused / undesirable equipment.
- If cleaned and tidied up properly, the room could be a great place for storing unused op…
-
To help automate billing, in addition to exporting the PI-specific CSVs, the processing script should also generate PDFs for them. Based on the PDFs we are currently sending out to PIs, the only addit…
-
Deploy the master branch to both raspberry pis for manual testing.
-
Currently, we require some "sudo apt-get" commands to get started with speech. Would be nice to have a bash script do this for us.
Also, would be cool to have this equlizer! https://www.raspberrypi.o…
-
Would be nice if this project had a pre-configured flashable ISO image for Raspberry Pis and possibly other single board computers. Installation and setup is ok but a flashable image would be so conve…
-
Maybe a note to the README that it won't work with newer PIs as they moved the Ethernet connector? Unfortunately I can't just dremel it out; would destroy PCB traces.
![IMG_6298](https://user-image…
-
Looking through the OpenThread page, I can find two different daemons for the OpenThread stack on linux:
- ot-daemon (https://openthread.io/platforms/co-processor/ot-daemon)
- otbr-agent (https://op…
-
Hi there,
I implemented the Mioty network using the Raspberry PIs.
For the sensor endpoint side I am using a Pico Pi with RFM69HCW which works well, as I tested using a spectrum analyzer; it trans…
-
-
Hello
I got the PIS installed and everything works fine.
But when i remove the PIS and reboot Klipper, it wont Boot and an Error shows "Not able to connect to MCU" or something.
Does the PIS no…