-
Here's a simple example with your library:
#include
#include
#define ADDRESS1 0x0A
Mycila::PZEM phase1;
void setup() {
Serial.begin(115200);
while (!Serial) continue;
phase1.begin(&…
-
### The problem
Access more than 4 PZEM-004T V3 at the same time,The data will not be read.
I set different addresses for each pzem.
No more than 4 pzem, everything is normal,Once more than 4, t…
-
### The problem
Constant crashes with PZEM016 module connected to d1 mini esp8266 using built-in 5V output from module, tried swap tx/rx nothing helped. It's crashing randomly, can run whole day with…
-
This is more like an RFC than a bug report, sorry for spamming issues for that.
Did some research into adding a voltmeter to openevse 5.5 hw. I am aware of OpenEVSE II but that looks like a history…
-
**Describe the bug**
I can open the KVM but I don't get a HMDI stream
The error message on console says to look at the status. That is pasted below.
```shell
# systemctl status kvmd-tc358743.ser…
-
I have used the library to work with Arduino UNO and it works fine.
With my Nodemcu-32S board, I am not able to get anything on the serial monitor when I run "PZEMHardSerial" example with "&Serial" i…
-
Hi I am using an Arduino Uno and tried to connect the PZEM-004-v30 RX -->D11 and TX --> D12.
when I compiled and uploaded the default example I gets always the following message in the serial monitor…
-
Hi,
Not an issue, just to say THANK YOU !
PZEM-004T multi works very well, I think you can remove [TESTING].
![F88CA2EF-95B1-4317-8C86-E4AE39B2FE13](https://user-images.githubusercontent.com/103516…
ipa64 updated
6 months ago
-
I'm working with 4 connectors in the same station, and it's working well, I use the build flag for num connectors and increase de buffer tx data for more connectors, but this message appears in the se…
-
Hi, I have finally created my own PCB for the ESP32-S2 and have had partial success with my LG Prestige split air conditioner. I can switch modes, temperature, fan speed and set horizontal and vertica…