-
Zwave stop working after upgrading from 1.8.1 to 1.8.2 (debian deb package).
Zwave aeon S2 USB stick.
I have errors in openhab.log:
2016-03-23 18:52:29.453 [WARN ] [e.jetty.servlet.ServletHandler] - …
-
Hello everybody. I'm struggling to get my network working reliably and would greatly appreciate any suggestions.
I started with a small Zwave-JS-UI network to test a few devices, and that was ope…
-
Is there support for over the air (OTA) firmware update of devices. COMMAND_CLASS_FIRMWARE_UPDATE
I was searching [http://www.openzwave.com/dev/index.html](http://www.openzwave.com/dev/index.html) bu…
-
After installing openrasbian 1.9 my razberryZ wich is connected to the serial Port AMA0 is not working. The device can Not be connected.
-
The 800 series application version NVM file `0x41000` is formatted differently on the Zooz stick than on the firmwares I can flash onto the devkit:
```
Zooz: 00 03 13 07
Devkit: 03 13 07 00
…
-
### Checklist
- [X] I am not using Home Assistant. Or: a developer has told me to come here.
- [X] I have checked the troubleshooting section and my problem is not described there.
- [X] I have read…
-
```
What steps will reproduce the problem?
1.Add a binary switch and control it. It's OK.
2.Remove the power of the switch and wait for a couple of mninutes until it is
declared as dead.
3. Put the p…
-
Hi All,
Ive setup my Raspberry Pi B+ running zway server via UZB1 with a licence, then homebridge for my thermostat.
The thermostat shows up no problems and updates but the lock shows in an unknow…
-
### Checklist
- [X] I am not using Home Assistant. Or: a developer has told me to come here.
- [X] I have checked the troubleshooting section and my problem is not described there.
- [X] I have read…
-
### The problem
I include brand new Eurotronic Comet zwave into my zwave network and I try to set parameter 6 (valve opening percent report). But when I requery device, this configuration field ret…