-
Hi there.
I try to use the SCL pin to command a 5 V relay to stand and stop air assist. but when i power the board the SCL pin is High and the relay si on.
when i try the m7 command the relay is…
-
First question: What if I wanted to control multiple lights or power outlets?
Second question: What if I wanted to make every component serviceable/replaceable without having to unsolder/solder anyth…
-
I'm using a very similar code to the one here for esphome and Home Assistant.
Everything works fine except that when the board resets or reboot all the relay are triggered.
Very inconvenient when co…
-
### What happened?
I have a long strip of FW1906 leds (RGBCCT) and a relay to turn off the power supply when not in use (using the built-in relay feature of WLED). WLED controller is always powered.
…
-
Hi, i need to use this board
https://www.olimex.com/Products/IoT/ESP32-C6/ESP32-C6-EVB/open-source-hardware
but i can't find a valid platformio.ini file
Thanks
-
Finished the signal generator (PCB 1) today. The 200hz and 20khz range worked as they should and THD was very low too, about 0,0005 % which probably is as low as I can measure.
How ever the 2khz ra…
-
Similar to the Sainsmart IP relay board, I was hoping for a module for the Sainsmart 16 channel usb relay board.
[https://www.amazon.com/SainSmart-16-Channel-9-36V-Relay-Module/dp/B0793MZH2B/ref=asc_…
-
### What happened?
If I connect a WLED ESP32 to a Wifi Network and then try “192.168.178.59/relays?toggle=1,0,1,0” it works!
But it does not seem to work if the WLED ESP32 is in “AP-Mode” (4.3.2.1…
-
Hi 👋,
I have the below Relay GraphQL query:
```
fragment expandedCard on Board {
__id // Cannot query field "__id" on type "Board".eslint(graphql/template-strings)
}
```
However, ES…
-
Sorry for the "issue" submission.
Here is the log from the app
```
(.venv) me@pzw-1:~/i2c_2_mqtt $ python3 mqtt2i2c.py config.yaml
Sent HA switch discovery {"name": "pzw-1", "state_topic": "I2C/…