-
Subject: | rotctl rotctld and 603 rotator error
-- | --
Sun, 24 May 2020 21:05:38 -0400
John LeRoy
hamlib-developer@lists.sourceforge.net
I pulled the nightly snapshot yesterday and I'm us…
-
Hi !
I'm currently trying to get the raw tracking data of the satellite (elevation and so) without using rotctld to process them later.
Is there any way to do that ? I've tried to make a "false"…
-
I am submitting this report on behalf of another ham. I don't have the hardware myself. His issue looked similar to the issue I reported about rotctld returning Ev and Az reversed. He built the lat…
ve9gj updated
4 years ago
-
To give you insight, I'm using Gpredict + rigctld to control my radio + rotctld to control my rotator.
Previously, I was using **20200405 snapshot build** which worked incredibly well on IC-910 to…
-
Hi,
I am running rotctl and rotctld (release 3.3) on Win 10 64-bit with a Meade Starnavigator az/el mount with a 497EP Audiostar controller. Per multiple sources, this hand controller is fully bac…
-
This is mainly a question about the protocol implementation: the bug can be either in Hamlib or K3NG firmware.
I'm trying to use K3NG rotator firmware (https://github.com/k3ng/k3ng_rotator_controll…
-
I’m running the satnogs-monitor on an Raspberry Pi 4 with the following command as instructed:
satnogs-monitor -l 1382 --rotctld-address 127.0.0.1:4533 --data-path /tmp/.satnogs/data/ --waterfall -…
-
I just did a clean build on Debian 10 that resulted in quite a number of warnings. I will put the warnings for each file in a separate comment in this issue.
```
CC netrigctl.lo
../../ha…
-
The current data format of rigctld/rotctld responses is quite hard to parse -- especially the capabilities list is a bit of a nightmare. I've been thinking of introducing an alternate data format, e.g…
-
Hello,
Is there a simple way for setting an offset in the azimuth? (for a case where an existing antena/rotor is installed with a misalignment).
Mechanically fixing would be better, but conside…