-
```
$sudo systemctl status dump978-fa
● dump978-fa.service - dump978 ADS-B UAT receiver
Loaded: loaded (/lib/systemd/system/dump978-fa.service; enabled; vendor preset: enabled)
Active: a…
-
Hello Jan!
I've checked out the latest Qt-DAB version for Windows over the last weekend and currently I take a closer look into the raw-recordings. Something went wrong...
Example:
Filename: …
-
I was hoping someone could help me out here. I have the Nooelec GOES dish, sawbird and a RTL-SDR dongle in windows with SatDump receiving GOES just fine but when I take my setup and plug it into my Ra…
-
The RSP (Radio Spectrum Processor) from SDRplay is a Software Defined Radio covering 100kHz to 2GHz with a 12bit ADC.
API and Android integration instructions can be found at http://sdrplay.com/api_dr…
-
There have been repeated failures from:
- a flooded Pelican case
- a GPS cable chewed through
- an overheating beaglebone due to poor heat transfer of **computer inside box inside box inside box** …
-
2020-05-23 11:00:41,908 INFO:APRS-IS - Uploaded to APRS-IS: OK1SLM-15>APRARX,SONDEGATE,TCPIP,qAR,OK1SLM-15:!5045.51N/01518.24E`radiosonde_auto_rx SondeGate v1.3.1 !w!R!
2020-05-23 11:02:56,236 INFO…
-
I'm trying to connect Gqrx to a remote server using the SoapyRemote protocol. Using Gqrx locally, with client and server on the same machine, it works normally. But when the client is on a different m…
-
#After a few days of using the RTLSDR-Airband seems a great project but I find that I need some functions not available, mainly related to the recording or scanning.
A small list functions that are…
-
from my tests with several RTLSDR dongles, good samplerates are up to 2400 kSps.
some days ago, i could verify that the samplerates
``` f(k) = 2400 + k * 40 kHz```
were also good .. up to 2880 kHz…
-
It would be great to have some instructions how to install this on Linux.
There are some DLLs mentioned in the instructions and also I think some stuff from requirements.txt might not apply to Linu…