-
Hi, I am looking for a serial plotter with an "overwriting" style, meaning that when the x axis reaches the end it restarts from left and overwrites the previous plot. In some cases, this would help t…
-
With values that constantly change, the range of the plot will shrink and expand, making it incredibly difficult to judge the amplitude of a plot without constantly re-checking the Y-axis (of which is…
-
I've changed the code to output only the bpm with the directions that were posted on a prior post and the readings are very inconsistent. It's clear that the sensor has not been working properly becau…
-
The variable "Setpoint" is the desired angle correct? What is its min/max values (the example just has "512")?
I normally use VS Code, but I went to the Arduino IDE to use the Serial Plotter to dia…
-
Hi, 1 of my Pulse Sensor outputs a higher reading as compared to the other pulse sensor. Why is that so? Here is the graph from the Serial Plotter: https://imgur.com/UXpDaQv
I am currently using the …
-
It displays 3 - 4 characters every 2 - 3 minutes
Cntl C takes 5 - 6 minutes to execute or more at times.
When i try a different mode the msg pops up "not responding"
i can't even Quit.
Even af…
-
### Describe the problem
There is no send button in the Serial Monitor.
### Describe the problem
1. Open the "**Serial Monitor**" view.
🐛 There is no "**Send**" button associated with the …
-
After looking trough the code again i am thinking it would be quite easy to add a graph of the current measurements,
As the Current is measure every 100ms but only shown every 3 Seconds we have pl…
-
Hello all,
Although I got some StallGuard values output, the results are hard to interpret.
I have the TMC2209 connected to an Arduino Mega via UART.
I have written a script where the motor acce…
-
Hi, I'm using an arduino nano 33 ble and the online Arduino ide which Arduino IDE version 1.8.13.
I've imported the libraries and can't get a single example to run, they compile (once the SPI initia…