-
We should really write a library for this device. It would be much easier if a .begin() function took a TwoWire, Serial, or SPI stream and then over-wrote the .print function. We did this on the Qwiic…
-
This may be in the wrong section and is so my apologies.
Library referenced at this address is no longer available
`
https://github.com/nemith/serLCD
`
Requires update or removal.
-
Hello,
Is there a way to use serLCD.h instead of the library you had implemented ? I'm using that library to communicate with a 1 wire serial LCD which are not supported yet by the LCD Libraries incl…
-
I just encountered the reason why my further test programs didn't show correct display outputs:
it happened when a SD card was plugged to the SPI bus additionally.
this is the SD init function:
```
…
-
```
What steps will reproduce the problem?
http://arduino.cc/playground/Code/SerLCD
in serLCD.h
"50.// Flags for display on/off control
51.#define LCD_BLINKON 0x01
52.#define LCD_CURSORO…
-
```
What steps will reproduce the problem?
http://arduino.cc/playground/Code/SerLCD
in serLCD.h
"50.// Flags for display on/off control
51.#define LCD_BLINKON 0x01
52.#define LCD_CURSORO…
-
```
What steps will reproduce the problem?
http://arduino.cc/playground/Code/SerLCD
in serLCD.h
"50.// Flags for display on/off control
51.#define LCD_BLINKON 0x01
52.#define LCD_CURSORO…
-
```
What steps will reproduce the problem?
http://arduino.cc/playground/Code/SerLCD
in serLCD.h
"50.// Flags for display on/off control
51.#define LCD_BLINKON 0x01
52.#define LCD_CURSORO…
-
```
What steps will reproduce the problem?
http://arduino.cc/playground/Code/SerLCD
in serLCD.h
"50.// Flags for display on/off control
51.#define LCD_BLINKON 0x01
52.#define LCD_CURSORO…
-
```
What steps will reproduce the problem?
http://arduino.cc/playground/Code/SerLCD
in serLCD.h
"50.// Flags for display on/off control
51.#define LCD_BLINKON 0x01
52.#define LCD_CURSORO…