-
Hi!
I'm having an issue with the heater from Ikhos warm slim.
I'm able to control the heater with smartlife, adjusting temperature, heating mode, target temperature.
But on Homeassistant I only c…
jmvaz updated
3 years ago
-
I was thinking about how could a regular thermostat behavior could be implemented, like setting the temperature on the go, no boost, no override or any schedule.
A slider, visible on the zone pop-u…
-
Just came in and no one was there but the thermostats where on 5.
Possible solutions:
* electronic thermostats that prevent heating on weekends
* make it part of the shutdown protocol to reduce h…
-
When setting min_cycle_duration to either seconds: 120 or minutes: 2 I get the same results with my cooling turning off/on every few seconds if the temperature is close to the setpoint.
Is there s…
-
we have now our summer in Europe. I use the relays for turn on, off the heating function, SG1 & SG2. I miss the cooling function.
Does anyone need it?
Can anyone help me to add this function?
T…
-
I have a heat pump with an expansion board that allows you to control two circulation pumps independently (i.e. you can have 2 independent heating/cooling zones). I have two independent circuits:
- f…
-
Is there any way to set the heat pump units to freeze protection. I can do it via remote by clicking twice on the down temperature once at the bottom temperature, but I don't see a control for it in …
-
This change would introduce the capability to link the underlying state of the heating system (e.g. 'heating', 'off') to the state of radiator valve.
It could work initially by getting the boiler s…
-
https://github.com/MindrustUK/Heatmiser-for-home-assistant/pull/75 adds support for new hvac modes. These modes are hardcoded however there are 2 minor problems with this:
1. Some hardware thermost…
-
I would like to see my climate device supported (#72).
Its a (I'm guessing) much rebranded device, as I've found it under multiple brand names. The manual however is always the same:
https://www.kl…