-
4squirts alternating basictrigger v8 2injectors.
Duty stops att 24.5% ????? and it goes lean.
Max duty is set to 98%
Swapt to MS2 and it goes upp to 95% att full throttle.
---
Want to back …
-
Hi,
during testing of black STM32F407VE6 board has been discovered, that external baro input doesn't work. When I tried to swap pins between various inputs, the problem moved with the baro pin, so it…
-
I observed this behaviour on a teensy 3.6 board, stepper open loop, minimum steps = 1, raising it makes the problem disappear, engine stopped, homing done.
Took a quick look at doStep() but been unab…
-
Setup a preprocessor macro(s) to have the timers do either all injectors or all ignitors with a total of 9 timer compares. There could also have a setup to have a split at different number of compare…
-
There are a bug in trigger_decoder.cpp, so the gap-check doesnt do whats intended.
The array toothDurations[i] should only capture one edge, but instead it capture each event.
Ideally, it should…
-
This is a feature request / firmware enhancement.
I would like to see the integration of water / meth injection control, both a basic on/off version triggered at a pre-determined boost level and al…
-
http://secu-3.org/forum/viewtopic.php?f=64&t=1047 mentions 19-01-2017 release but this repo is not updated since 2016. Is this firmware closed source now?
Sorry to hear about the clones :(
-
The last months, I have not made any firmware-versions running without trigger-issues.
The car just stops and throws trigger-errors.
I have a older firmware running without this problem.
The car …
-
Hello all,
I am in a situation where I would like to add *1 fuel rail pressure sensor to my speeduino.
It seems like there are two ways to achieve this:
1. Modify the code to use one of the m…
-
Is there anything special I need to do to add items to the ini file now that we have CRC support? I have added some items to then end of page=1 (config2 in the code) but whenever I burn them I get a C…