-
Not certain if I'm doing it right, but here's what I have.
using bios version 4301 from [here](https://rog.asus.com/us/motherboards/rog-crosshair/rog-crosshair-vii-hero-wi-fi-model/helpdesk_bios) (yo…
-
Below is the libsel4 definition of `seL4_TCB_WriteRegisters` for AArch64:
```
seL4_TCB_WriteRegisters(seL4_TCB _service, seL4_Bool resume_target, seL4_Uint8 arch_flags, seL4_Word count, seL4_UserCon…
-
I was working around with the default ```vm_minimal``` for ```qemu-arm-virt``` 64bits platform and tried to allocate 2GB RAM for the VM linux and got some allocation fail error.
```
./simulate: QEMU…
-
I spotted something interesting while compiling a bootloader and trusted-firmware for an mt7981 device, but haven't been able to debug it yet. I'll have a go at digging into it over the weekend if I g…
-
Hi,
I find your code really helpful for the development base in firmware simulation,
but it turns out that L1, L2 cache simulation (such as hit/miss rate) results do not appear in the stats.txt.
Is…
-
The OP-TEE developer build fails to boot on my newly purchased RPi 3B+ board. I believe I've traced the issue down to a recent board revision (late 2022) that is incompatible with the old (~2019) rasp…
-
BulkOnly::Transaction() fails with INVALID_CSW for Arduino boards that support SPI.transfer(buffer, size).
The problem is that this call in BulkOnly::Transaction() :
`while((usberr = pUsb->outT…
-
I purchased a Pioneer 1.3 bare board, and I am at a loss for how to get this thing to boot.
I have tried various combinations of the following RAM and boot media:
- 1 stick of NEMIX RAM MR25600-…
-
I'm unsure what actually caused this panic, but the situation was that I had a cloned interface `lo1` in `/etc/rc.conf` and issued a `service netif restart` while ssh'd to see if things work. Attached…
-
I tried use command nexutil -k157/80 to change the channel spec to Channel 157 and 80MHz bandwidth.
And then I use nexutil -k to check if I had set successfully. The output it not 157/80 but
chans…