-
Just got a serial port AVR910 prog (based on AT902313 and use some passive components for the serial interface) from AliExpress (along with a serial port based SI-Prog).
Currently avr910 only supp…
-
I got `Serial port error:read timeout` in `Erasing flash` with device STC15W4K48S4.
Environment info:
```log
OS: Windows_NT MinOR-SZM 10.0 19042 x86_64 MS/Windows
USB-UART: USB 串行设备 (COM3) USB…
-
[24.08.2023 12:09:22] jasiu-rozowyczlowiek:
[24.08.2023 12:09:22] jasiu-rozowyczlowiek
-
As the title suggests, after one hardship, another one.
This issue currently occurs when the following combinations are met:
- git main
- Use "jtagmkii_updi". (Is it just jtag2updi?)
- Target …
-
I have been trying out the "pwm_dac_voice" example from the Demo folder on a STC8H8K64U chip, not too sure if I am doing anything wrong but I am just getting screeching noise from pin P1.0 instead of …
-
I have a STC15W101 mounted to a circuit board (sonoff door sensor).
This chip apparently has 128 bytes of RAM, 1KB of code flash, and 4KB of EEPROM flash.
It appears that just gpio hal alone requi…
-
Using an Adafruit FTDI Friend on macOS High Sierra and trying to flash one of those DIY clocks from BangGood/Amazon. Mine is running the STC 15F204EA.
I have my FTDI Friend's Power and Ground conn…
-
### Describe the issue you are experiencing
NOTE: THIS APPLIES 9NPY TO OFFICIAL ADDONS, AND TWO USERS FROM SAUDI HAVE REPROTED THIS.
i am running home assistatnt and i cannot update any of the a…
-
**Environment:**
Platform: RS V1.0.1 OPS Orange Cloud
Configuration: rs-config branch op based on 0.5.0-rc1 MIS / rs-processing-config 0.4.0-rc2
**Current Behavior:**
Many products gener…
-
Johnny Quest
Sat 18 Jun 2016 04:51:15 AM UTC
Hello:
First off, I have done my homework on this matter and would not have posted seeking assistance unless it was a last resort. smiley
This message …