-
I've flashed OSH_PB_Controller_0.16.hex to my stm32f103c8t6 but in OSHStudio main screen there is no any mark that my device as connected. How can i fix this?
-
Hi everyone!
I'm developing a HID Joystick with DFU on STM32F103C8T6 (Bluepill), and I have a question...
I'm fighting with some things, the first is the Internal flash of DFU, without this the …
wamk9 updated
8 months ago
-
I'd like to suggest a potential alternative to the Cypress board: [My USB Floppy Adapter](https://github.com/roybaer/usb_floppy_adapter)
It uses the same [STM32F103C8T6](https://www.st.com/en/microco…
-
My board's MCU: STM32F103C8T6
[I change the TFT support back to the Serial support.]
RESBI updated
6 years ago
-
I am setting up STM32F103C8T6 and ESP8266/ESP-01S via AT commands and looking for webserver to work on the system.
My setting is in visual code:
```
platform = ststm32
board = genericSTM32F103C8
…
-
Hello everyone!
Is it possible to make the firmware compatible with another STM32 MCU's?
The STM32F103VCT6 is a little expencive but STM32F103C8T6 for example if only a couple of euros.
Al…
-
I have a stm32f103c8t6 board
I use the display screen to connect Arduino compilation and run without problem!
But I need to connect the display screen with STM32 and compile it on Arduino ide
…
-
Hi
I tried to compile your code for stm32F103C8T6 and get the error message sdfat.h not found.
I tried some libs I found, adafruit etc. It does not help out.
May I ask you which lib you are using?…
-
Hello. I have a problem with hx8357 and bluepill. The display does not work if the frequency of stm32f103c8t6 more than 7 MHz. On 1-7 MHz it's work, but very slowly, if it’s more, the backlight just t…
-
Sounds like this is might be a known issue but couldn't find anything:
Chip: STM32F103C8T6 ARM STM32 Minimum System Development Board Module
![image](https://github.com/blackmagic-debug/blackmagic…