-
Add new branch with new developments in Marseille.
I suggest keeping the same structure, so inside the docs folder -> one new folder for every development. In that folder, an MD file for descript…
-
I'm trying to add support for Thorlabs ELL Multi-Position Sliders. Models ELL6, 9 and 12.
These devices are controlled through a serial interface.
- These linear stages seem to respond to the com…
-
Hello -
First, thank you for writing this interface software for so many types of lab equipment, it is very helpful.
I think I've found a bug: when I try to jog any channel 3 on a Thorlab's Ki…
-
Hi,
The channel 3 with a KIM101 Piezo Controller is not working properly as it switched automaticlly to channel 4.
In the following example the channel 3 is enabled correctly at the KIM101. Howeve…
-
Hello,
I have a CS165MU camera from thorlabs and I want to grab frames from the camera in real time and process them on the fly.
I noticed that there is support for the TSI SDK in instrumental, but …
-
This problem is the underlying reason I made #44 -- but rather than self-diagnosing perhaps this is a more general issue in Instrumental.
I have loaded two thorlabs camera objects, cam1 and cam2…
-
I know pyLabLib wasn't tested on the Thorlabs BSC 203, but when I can see it when I ask for a list of Thorlabs APT devices. However, whenever I try to communicate with it I get an error, stating that …
-
Change pulling velocity depending on certain conditions, such as:
- [x] Always maintain proportion relative to brusher velocity
- [x] Stop pulling in HZ edges
- [ ] Decrease pulling velocity if H…
-
The following function `setup_kcube_trigio(trig1_mode="out_maxvel", trig1_pol=1)` should declare a trigger output pulse when the stage reaches its maximum velocity.
Currently, the motor sends a tri…
-
Continuing the discussion in sinara-hw/meta#52 ([comment](https://github.com/sinara-hw/meta/issues/52#issuecomment-624352053)) on cheap monitoring photodiodes for Sinara.
- Something like Thorlab…