-
Hi,
I've just found your great project! Would it be possible to add other chips (looking for Attiny1616 debugger currently)?
Is this project based on reverse engineering the debug protocol or is…
-
Hi.
I use Attiny3226 on megatinycore. I want to 16 pwm output from PA4 pin. But I am not success it?
Please take sample sets.
Thanks.
-
Hi,
I'm using and attiny 804, and I need to wake up from sleep to power a couple of LED strips (yes, you may have seen a similar code elsewhere). The code is this:
```
#include
#include
#includ…
-
@Spence,
Just found out that your great DxCore is available for PlatformIO!! Fantastic!
Is there a change you will make the megaTinyCore also available (in the near future) for PlatformIO??
H…
-
As reported by @askn37, there is an issue with programming NVM V3+ chips when the boot operation is not fully completed. This results in NVM controller not accepting `NVMProg` key and can cause progra…
-
Hello!
Is it possible to add Wurkkos TS11 / TS25 support? They seem to share the same firmware, code `0715`. I found the config file [here](http://bazaar.launchpad.net/~gabe/flashlight-firmware/and…
-
hi, i would like to drive 4 PWM led drivers with an attiny 84 MCU, i noticed i can not get all channels to output at same frequency, the datasheet suggest a prescaler of zero can be applied to both ti…
-
@SpenceKonde I know you do not have the time to dive into platformio questions, but I hope someone else is willing to help me!
I am trying to get my AVR128DB28 MCU to reset using .. well, the RESET…
-
I'm not sure if this is possible, but I was wondering if these usb dongles can be used as linux gpio pins via the libgpiod device manager.
So they can show up as:
`/dev/gpiochipN` where N is the c…
-
Using pip version from pymcuprog, and serialupdi, in attiny 2 series (3226).
With "-v warning", there are no logs on the progress of the programming.
With "-v info", there are way too many log lines…
hb020 updated
11 months ago