-
Hi,
i have a problem, i'm trying to use two TMC2209 at the same time, but no matter how i configure the uart addresses, each time i operate one of the TMC2209 it does the same thing on the other one.…
-
Hi there,
I'm trying to run stallguard for homeing and tried several methodes, however [#191](https://github.com/teemuatlut/TMCStepper/issues/191) helped me most.
Anyway I got a strange behaviour. …
-
Hi. Sorry for my bad English.
Thank you for your great work, teemuatlut.
I need help, I don´t understand the line:
#define DRIVER_ADDRESS 0b00 // TMC2209 Driver address according to MS1 and MS2…
-
After I have installed the firmware "For Ender3 TMC2209 + 3Dtouch" via an SD card and want to approach the reference via "AutoHome", the printer moves to the stop of the X axis. The stop for reference…
-
Hi,
The **TFT35 E3 v3.0.1** connected to **SKR3-EZ** shows **"no printer attached"**
### SKR3-EZ
Using the latest marlin firmware with the following changes:
- file: Configuration.h
```cpp
#de…
-
Does the Diag-Pins from the Stepper needed to bend by side or cutted of if using the Fystec TMC2209 V3.1 with the Spider V1 WITH Endstops?
-
I have recently upgraded to a SKR 1.3 with 5 BIGTREETECH TMC2209 drivers. The firmware is all configured, but the LCD shows 'TMC Connection error'. M122 also shows this.
![IMG_0218](https://user-ima…
-
Good. I saw that you use the tmc2209. Are you using it with the original gt2560 v3 board? If I buy this configuration do I have to use it too? Or do I need to change something? Thank you very muc…
-
https://github.com/bigtreetech/BIGTREETECH-TMC2209-V1.2/blob/master/manual/TMC2209-V1.2-manual.pdf
https://github.com/bigtreetech/BIGTREETECH-TMC2209-V1.2/blob/master/Schematic/TMC2209-V1.2.pdf
The …
-
I have a skr 3 with tmc2209 driver in uart mode and sensorless homing and all works fine, so i decided to upgrade my drivers to ez2209 with ez driver connectors for better heat dissipation and afte…