-
I have tried five different boards. Version 1.1 and 1.2. 7670E, all the same problem; Works perfect when Board is always on. With deepsleep every board has the same problem; sometimes it runs for a fe…
-
Opening a new issue in this repo based on issue described here: https://github.com/TinyCamML/OMVmodel/issues/11. Issue pertains to setup where Boron and OpenMV are connected and powered by solar panel…
-
I'm looking add to network, a wired tally unit which act like a server, in order to avoid Atem freeze
I found Wt32-eth01, which lack USB port, but I found a USB to UART TTL board to add, so, proble…
-
Thanks for creating this guide
Side note: this is not an "issue" per se, but since the discussion tab isn't enabled, I filed it as one. Any chance you want to enable discussions on this repo?
I…
-
FIrst of all, I'm extremely new to MCU programming so sorry if I'm asking something stupid.
Is it possible to get the debug output over USB? Via serial, uart, I don't know. I have a CH582M in one o…
-
### What happened?
Everything was working fine on 1.38.0-dev but since I switched to 1.39.0, z2m started crashing randomly every couple of hours.
The log shows a random crash started with a transact…
-
If I print to the UART (the one via the usb port that is also powering the board) at full speed then the output becomes garbage. I use GTKTerm. If I switch to RTS/CTS or Xon/Xoff flow control then it …
-
**What kind of new feature are you looking for?**
- Hardware: Support for CH347 based hosts such as https://www.waveshare.com/wiki/USB_TO_UART/I2C/SPI/JTAG
- Software: Windows mostly but could check…
-
### Board
esp32-c6-devkitc-1
### Device Description
ESP32-C6-DevKitC-1 V1.2
Also occurs on another custom ESP32-C6 board (ESP32-C6-WROOM-1-N8CT-ND)
### Hardware Configuration
Nothing else conn…
-
I'm not quite sure how to use UART0 in your "baremetal development environment." I don't want to make a mess, haha. Could you send me a small proof of concept to print some debug information at 11520…