-
新客户端已经改了radius,貌似是随机值了.
-
型号 | Netgear WNDR4300
架构 | Atheros AR9344 rev 2
目标平台 | ath79/nand
固件版本 | OpenWrt 22.03.5 r20134-5f15225c1e
Xray-core版本:1.8.3
安装以后，service里有xray，但是没有自启动，service start xray也没法启动
-
The relay mode does not work on my OpenWRT router. Devices on LAN can get inet6 addr but are unable to ping any public ipv6 address. By Googling odhcpcd and ipv6 relay, I find many similar problems …
-
Upgraded from 22.03.0-rc1 to rc4 with fresh config on my Archer C7v5 and I noticed my speedtest dropped from 500/100 to 240/100.
Also occur on my Deco M4Rv2 with Openwrt 22.03.0-rc4 firmware installe…
-
### Describe the bug
Hi @nbd168,
Similar to this pull https://github.com/openwrt/openwrt/pull/12702, when built from master using test kernel 6.1 for Netgear WNDR4300, I got following error
…
-
### Describe the bug
Router ends up with a blinking green light.
Responds to ping at 192.168.1.1.
Does not allow web or ssh access.
See thread at https://forum.openwrt.org/t/23-05-sysupgrade-q…
-
*rvernica:*
On a NETGEAR WNDR4300v2 with stock firmware I flash OpenWrt. It works fine after flash (not power cycled *yet*). On the first power cycle the device is fails to start. I'm able to restore…
-
*buletti:*
**Description:**
I have 3 WIFI access points (2x Netgear WNDR4300, 1x Netgear WNDR3700v2) running 19.07.4 r11208-ce6496d796. Each of those APs has a 2.4 and a 5 GHz band. For each of th…
-
## Steps to reproduce:
1. install ds-lite/6to4/6in4/6rd
2. goto Network->Interaces->Add new Interface->this protocols not offered
or add i.e. 6to4 as protocol inside /etc/config/network
then N…
-
Maintainer: @hnyman @jow-
Environment: ath79/nand - Netgear WNDR4300 - OpenWrt 21.02.3 r16554-1d4dea6d4f
Description:
After setting up collectd and the mqtt (network) plugin, it connects to the c…