-
### Describe the bug
Hello everyone, I'm experiencing an issue where GSConnect is unable to send files or photos from my iPhone to my PC. However, **all other features of GSConnect are working perf…
-
Hello,
I have a problem of wifi not associating with the AP, in some of the boots. It is configured and it works, but in some of the time the wifi will not associate. I have to connect the ethernet…
-
Hello, fresh install on RPi5.
Initially, I was setup over hardwire so eth0 was setup and running. Then I setup the wifi and found that the LCD display was not updating the Rx and Tx bytes correctl…
-
I use spi+ng1.0.2 solution.
We are able to connect to wifi, it works well. but when I turn off the wifi hotspot, and turn on again, esp32 detects the disconnect event, but it does't auto scan and a…
-
Hello,
In file wpa_supplicant.conf:
> ctrl_interface=/var/run/wpa_supplicant
> ap_scan=1
> network={
> ssid="your_wifi_ssid"
> scan_ssid=1
> proto=WPA RSN
> key_mgmt=WPA-PSK
> pairwise=CCMP TKIP
> g…
-
### Describe the bug
k3 划分vlan后导致WiFi无法连接，提示密码错误，去掉WiFi密码可以正常连接和上网。
### ImmortalWrt version
r20074-a8bbadefaf
### ImmortalWrt release
21.02.7
### ImmortalWrt target/subtarget
bcm5…
-
Hello,
I want to change wpa tkip security to wpa-aes or wap2-tkip, wap2-aes.
How can you change it?
-
Occasionally, if I switch from AP to bridge mode via the web UI, the wpa_supplicant file fails to fully write my information and therefore I cannot start up in bridge mode. I checked wpa_supplicant_wp…
-
Linux kali 4.19.0-kali3-amd64
Branch: 5.6.4.2
Radio: AWUS036ACH
wpa_supplicant v2.9
Nothing happens at all, only "Successfully initialized wpa_supplicant" weighs, in dmesg is empty
-
Does anyone have a working wpa_supplicant file A P use on a P0W?
I am struggling to understand what I should be using at the moment.
Thanks