-
Hi - Still working on getting the BugFix version to work. Downloaded a new RCBugFix branch today and am getting an issue with the ABL functionality. The probing starts in the center (X0 Y0) and moves…
-
Hey,
So I was running the TMC5160 over SPI on a SKR v1.3 for quite some time without any issue.
Due to a heatbed upgrade I moved to a 24v PSU and problems started.
Using the exact same klipper…
-
I have a model that does not slice properly if particular settings were applied. I did not identify what settings exactly influence it, but I am attaching a working and a non working .ini
This happ…
-
### Bug Description
my bltouch v3.1 is probing but my first layer not even near being level, i have pre leveled the bed manually.
i've checked my axis steps but even after adjusting them,it's not …
ase95 updated
3 years ago
-
Hi
When homing with 1.1.3 , and boundaries setted like ' XMIN=30 , when the carriage is on the xmin switch , then firmware is on XMIN , on the lcd we can see ' 30 ' and we are on the switch in t…
ghost updated
3 years ago
-
Hi, my setup is almst done (missing frame pieces), but i can adapt the ectronics to the machine
what is the minimun requirements (inputs/outputs) for this project?, (a Fysetc AIOII https://github.c…
-
There is a board on ESP32. Compiled the firmware based on Marlin 2.0.9 and Esp3dlib. But there is no connection between the WEB interface and the firmware. A similar GR BL firmware works on this boar…
-
Some files it makes 3 loops even tho that there are only 1 loop in the settings
i can set to 1 2 3 loops and there is 3 loops, allways.
4 loops it makes 4 loops, 0 loops and it is gone as normal.
…
-
This issue was initially created to enable collisions detection between 3D objects and make it configurable through an optional param, but the conversation derived in depth calculation to avoid collis…
-
### Version
Prusa edition 1.39.1
### Operating system type + version
Windows 10, 64 bit
### Behavior
Applies too many loops on the skirt.
Set to 1 loop at 5mm, minimum 150mm (tried a few var…