-
I have installed a S42B (pre assembled) only on my Y axis using a SKR 1.3.
When printing in closed loop the stepper stops or will jump large distances.
I have modified my marlin 2 for the correct st…
-
The BTT TFTs have a manu for manually testing the BlTouch probe. In there you can test the probe, deploy it, stow it..., but there is currently no support for the Biqu Microprobe. Since the Microprobe…
-
The configuration steps are outdated and misleading. Marlin 2.0.x implements the FYSETC variants natively.
There is no need to edit the `pins_RAMPS.h`.
In `configuration.h` search for **FYSETC_M…
-
Hi! I have plugued an ESP32CAM to TFT32's WIFI UART. I can ask temperature, move motors, and do other things; But how can I get list files from TFT SD slot (and/or USB)? Is it implemented? M20 give…
-
Hello!
Is there a possibility to connect [TS35 touch screen](https://github.com/makerbase-mks/MKS-TFT-Hardware/tree/master/MKS%20TS35-R/MKS%20TS35-R%20V2.0_002)? If I understand it correctly, it's …
-
Hello,
After three or four solid prints my Ender 5 Plus with the mentioned main board halted mid print and went full tilt with bed and hot end heat All controls were unresponsive. Now when the mach…
-
Unable to build with platformio.
Error promted
> Executing task in folder Marlin-2.0.x-SKR-Mini-E3-v1.2: platformio run <
Error: Unknown environment names 'BOARD_BIGTREE_SKR_MINI'. Valid names…
-
So I have a new board that I setup with the firmware powered via USB. When I changed over to normal power (took out the jumper) the board powers on and seems to be working fine however the HE0-HE3 ar…
-
Please consider Disable Linear Advance by default in firmware as per @morningreis guide with tweak for SKR E3 Mini v1.2:
- https://www.reddit.com/r/ender3/comments/dojh3v/guide_for_those_upgrading_…
Hedda updated
4 years ago
-
I’ve been working and testing the new skr v1.3 with TFT35 v1.2.6 on pronterface. I updated the TFT to v1.2.11 and then tried to connect to pronterface. I’m not able to connect. Pronterface just says c…