-
I would like to change the XY Datum from lower left to center of workpiece. I have tried using the offset but that only moves the lower left position by amount of offset. Perhaps a custom button?
…
-
I have a very cheap chinese engraver using belt drive for movement.
When engraving a picture line by line, I can only see it working bidirectional. This goes fast but is a problem with cheap machines…
-
I have a gcode program for my laser engraver that uses X movement a lot but very little Y movement (raster engraving), which makes Y stepper become very hot when in holding torque mode. How to tell gr…
-
I am running LaserWeb4 on a Raspberry Pi 3 with the stock 8MP webcam. I am running Raspbian Stretch version 4.9.41-v7+.
However, I cannot configure the Raspberry Pi camera in the LaserWeb4 settin…
-
DK-8KZ isn't working for me when I use Ubuntu/Linux. (I have just tried with Win7 and your program, can upload and start burning. with win7 laser engraving with DK-8KZ working fine, I did also install…
-
Hi,
I am new to this and hope you can help me.
I am running a velleman k8200 3d printer that I want to use as a laser engraver.
The baud rate I have defined in the 3d printer software i 25000…
-
_From @RoDuth on December 20, 2015 6:20_
Have been using printed labels for some time now and are looking to go to engraved plastic labels very soon. I have been speaking to the local engravers and …
-
My lasers are capable of 15,000 mm/minute.
It would be nice to have the option to speed up the laser rather than dim it.
I think jobs would get done much faster and you would have much more depth t…
-
Why it is required to press abort twice in order to fully complete an abort and clear the alarm?
This seems to be the case with both Smoothie and GRBL.
Is this double process really necessary or c…
ghost updated
7 years ago
-
I want to move my device around and then choose a new position as home so when I eventually send a G90 G0 X0 Y0 Z0 command it will go back to that spot. How do I do this?
Do I need to do a soft reset…