-
-
The description of the MASTER_ON_HOLD bit in the IC_RAW_INTR_STAT register on page 499 of release 1.3.1 of the RP2040 Datasheet is as follows:
>Indicates whether master is holding the bus and TX FI…
fivdi updated
2 years ago
-
I've been playing with the rain detection, with "manually" generated rainfall, and have identified another issue with the code as it stands.
When the system is put into sleep having woken from a ra…
-
Hello MrYsLab,
Thank you so much for sharing this port for the pico controller.
I have it working on the Arduino Nano RP2040 Connect with 300 (well 290 after some debug) LEDs.
I had some really…
-
Im writing a USB volume control using a Pi Pico - and Im having issues with the volume control sticking or repeating on either direction (up or down) intermittently.
At first I thought that it was …
0xa10 updated
2 years ago
-
7.2.4 and some earlier versions have a problem with GPIO0 being used for board.UART() on the Feather RP2040. The following program will hang and then USB will disconnect after 10 iterations, due to th…
-
Not sure if best to ask/mention here or discord or forum...
I have been playing around with adding ability to talk to Dynamixel Servos, as mentioned in the couple of PR's and earlier issue.
For th…
KurtE updated
2 years ago
-
Currently, a range of things seem to be working on a small RP2040 board I'm testing with, based on v0.9 and the "get you started" SD card download - I've made no changes - but attempting to enter CP/M…
-
I have followed the steps detailed in https://datasheets.raspberrypi.com/pico/raspberry-pi-pico-python-sdk.pdf to the dot, in order to build the MicroPython ports/rp2 firmware in my system (Ubuntu 20.…
-
This issue-thread shall serve as a collection of breaking changes and otherwise noteworthy information to be part of the Tock 2.1 release notes. This is in addition to a final pass over the merged com…