-
Hello,
I have been trying for several days to get a LED display from Lysonled (P3 1/16 scan, 64x32 pixels) with FM6126A chipset to work.
I get a picture displayed but the result is strongly fals…
-
On an rPiB, I run
~/rpi-rgb-led-matrix/examples-api-use/demo --led-gpio-mapping=adafruit-hat-pwm -D 0 --led-rows=64 --led-cols=128 --led-multiplexing=0 --led-row-addr-type=0 --led-chain=2 --led-show…
-
Hi,
I made a board using the schematic found for the ESP32 SmartLED shield V0 pinout (non through hole). I have just put this together and I am having issue getting the display to work correctly.
…
-
rgb.pixel(255,255,255,0,0) works
rgb.pixel(0,0,0,0,0) after that doesnt and requires a clearing of the display
-
I am trying very hard to make work a 64 x 64 panel with a FM6126A register shifter, unfortunately without success. I see you updated this library to support this chip.
I am using an ESP32 dev board, …
-
Hello!
I have an big issue with my LED setup. I have an RPI3, an Adafruit LED Hat and four HUB75 16x32 Panels. I have connected these four panels in a chain. I had compiled the led-matrix library wit…
-
Hi,
I found a tutorial (link below) and when I add the number 64 the clock signal stops being done:
Not works:
RGBmatrixPanel matrix(A, B, C, D, CLK, LAT, OE, false, 64); // 32x64
Works (wit…
-
While this is an amazing library, to get a better understanding of how these panels work, I’m trying to understand the native protocol.
Looking at the pin out, it seems like it’s just a straight-up…
-
### Hardware:
Board: ESP32 Dev Module C
Core Installation/update date: 10/apr/2018
IDE name: Arduino IDE
Flash Frequency: 80Mhz
Upload Speed: 921600
I'm not sure where t…
-
Hello !
I've tried a simple code:
```
#include
#include
#include
#include
#include
#include
#include
#include
// ========================== CONFIG START ====================…