-
I'm on my second board now, and it destroyed the USB controller on my PC.
The first board made the USB wire hot and burned the USB connector on the board.
This board is starting to feel unsafe, i …
-
My SKR 1.3 isn't updating itself from SD card anymore. I put firmware.bin onto the sd card on the SKR 1.3 and restart it. Either by using the reset button or the power cycling it. Then I insert the sd…
-
I have an example dual endstop for lowrider. I believe it is dual yz. But the Z endstops are a problem.
I think it would be best if the home dir was +1, and we set up the probe on Zmin. The two Z e…
-
I've downloaded Visual Studio and installed PlatformIO. Now I'm trying to compile Marlin, downloaded from BigTreeTech github repository, and after I open the project, I make the build without changes …
-
Buzzer tone is annoying on power on
would be nice to bypass alerts till power-on complete, or for first some "boot-time" seconds
-
Hey, I have the ebb sb2240 with a different cable shape than the one advertised (came in the box) and the STL doesn't fit around the connection,
Cheers
-
Whenever I use this plugin to save the gcode to file, I can't use the Eject function to close the drive access before removal. This works fine when I save to drive without the Bigtree3D plugin.
It …
-
It would be good to get documentation for Mini12864 display.
Minimum needed is pinout and corresponding Marlin settings for it.
-
When uploading file to SD card through esp-01 wifi module send printer into error.
This can be reproduced by entering the command "M28 test.gco" in the command console of the printer.
An empty fi…
-
Hi, Thanks for sharing this bootloader + firmware. I have an SKR-2 which should use the same bootloader. Where did you get the source for the bootloader? Would you mind adding it to this repo?
Than…