-
```
What steps will reproduce the problem?
1. Set the mode switch to FBW_A at any point.
What is the expected output? What do you see instead?
Expected output: Control surfaces should respond to iner…
-
```
What steps will reproduce the problem?
1. Set the mode switch to FBW_A at any point.
What is the expected output? What do you see instead?
Expected output: Control surfaces should respond to iner…
-
```
What steps will reproduce the problem?
1. Boot Arduino
2. Log pages are iterated
3. Select 3 to exit logmode
4. Code waits for slider to be switched which does not exist on the
non-shielded mega.…
-
```
What steps will reproduce the problem?
1. Set the mode switch to FBW_A at any point.
What is the expected output? What do you see instead?
Expected output: Control surfaces should respond to iner…
-
```
Which board (stock / gruvin9x / sky9x / Taranis) are you using?
stock (Turnigy 9XR with ATmega 128; BOARD_M128)
What is your openTx FW version?
opentx-9xr128-heli-templates-nosplash-battgraph-t…
-
```
I think it would be neat with all propellers in the same level spinning the
same direction. That gives some obvious advantages:
Less (and also more stringent) "Y6 yaw issue", because the differe…
-
the description comment on the open spin landing page is
"Add to Github"
Please change to something descriptive such as
"compiles SPIN source code file into EEPROM firmware image for the Propeller …
-
Spinning propeller (the blurred circle) sometimes disappear, although I couldn't narrow down in which conditions this happen.
@wlbragg also wrote:
> I notice it when I flipped upside down and it sta…
-
```
What steps will reproduce the problem?
1. Boot Arduino
2. Log pages are iterated
3. Select 3 to exit logmode
4. Code waits for slider to be switched which does not exist on the
non-shielded mega.…
-
```
What steps will reproduce the problem?
1. Set the mode switch to FBW_A at any point.
What is the expected output? What do you see instead?
Expected output: Control surfaces should respond to iner…