-
Hello,
I am using the Skr pro with a raspberry running octoprint as the main host. I'm using the ESP3D as a host, too.
And i also have a touchscreen connected to the raspberry. Until now I'm using…
-
I've noticed the capacitors used in the charge pump terminals of the drivers were rated for 50V while the datasheet recommends 100V.
Datasheet page 13 of "TMC2160 DATASHEET (Rev. 1.02 / 2018-NOV-19)"…
-
Hej,
I'm trying to implement a homing routine with Stallguard. (TMC5160)
Normally I'm running the drivers via SPI in Position mode.
For homing I switch to Velocity mode. But since I'm not using th…
-
Wow, this project looks awesome!
I am a big fan of the TMC5160 and I am looking forward to see your board running
are you sure about the sense resistor value? I think 0,075 Ohm is a bit low
The a…