-
Hi! I recently purchased a Hermit Crab & an H2 extruder for my Ender 3 v2. I'm having a problem determining how to connect the Hermit Crab to my 4.2.7 motherboard. The provided wiring harness has seve…
-
### What kind of mission do you want to add (mark with an X, e.g. [X] Descent)?
- [ X] Mansions of Madness
- [ ] Descent
### What expansions does the scenario require?
- [ ] Conversion Kit (…
-
Are there any plans to add ota firmware updates in the future?
-
Hello!
First off, thank you so much for adding this abstraction layer. Finally I see a real value for the Touch Bar!
I've noticed when my device is locked, the MTMR Touch Bar is gone and the def…
-
I have these installed on the X and Y axis of my printers and setup via LCD. They do not move no matter what I try. They do however power on and hold the motor.
I have the driver off in Marlin, o…
-
Hi!
Is it possible to improve Pin Mode so that you can pin any application by keyboard shortcut at the moment when it is necessary?
For example, how it is implemented in the BetterTouchTool utilit…
-
Hi everyone! I am very new to all of this and decided to install the BTT SKR mini E3 v1.2 board in my ender 3 pro. After install of the new board, my printer will not auto home. I think the X Y end-st…
-
Hello, I have bltouch with z homming but i look the picture and i not have the pin in my card for gnd, yellow ans +5V
my card : https://www.amazon.fr/gp/product/B082CJHKYC/ref=ppx_yo_dt_b_asin_title…
-
It would be great if the use of 3 (or even 4) pin PWM + Tachometer fans could be documented.
For example - is it "safe" to use the PA0 (FAN0/1 header) for +/- and a single pin from the I2C header, …
-
Hello!
This algorithm is fantastic and I have really enjoyed using it on my project. I find that it is spot-on when given a solid SNR and when the parameters are tweaked (I have tested it against b…