-
# Overview
When you use multiple instances of the same tip rack in a protocol, tip rack calibration visits each one.
When the protocol is run, the offset applied to each of those tip racks is th…
-
I start the printer and release the motor and set the x position to the left side.
After this I start a print job (chessman) via octoprint 1.3.12 on octopie 0.16.0.
At the end of the job the hotend …
-
## overview
The expected action for `InstrumentContext.dispense(DISPENSE_LOCATION)` would be for the pipette to dispense the entire volume to the defined location.
## current behavior
In the cur…
-
# Overview
The `opentrons_24_tuberack_nest_1.5ml_screwcap` labware appears to have a problem with both its x-spacing and y-spacing.
The tip will correctly be positioned in A1. However, in D6, th…
-
## overview
While performing an aspirate then dispense function on the same location, the pipette moves ~.5 mm toward the deck.
If an aspirate function is performed after the dispense the pip…
-
Trello URL: https://trello.com/c/TMTCsRlj
Google Drive Folder: https://drive.google.com/drive/folders/1nQkvDKQpPW6gZzxSCVSUqHyq7QSmIXz-
Category: Nucleic acid purification
Robot: OT-2
Pipettes: p10…
-
Trello URL: https://trello.com/c/Tg1uD8cY
Google Drive Folder: https://drive.google.com/drive/folders/19eYDGQRLKQa3mFv63bhuyjsw7m7_c4G2
Category: Sterile workflows (cell culture and related assays)…
-
When we move pipette gen2 to production, we will stop production on gen 1s. That means they will no longer be available during robot production to run CLI deck calibration, and may not be available to…
-
## overview
When dispensing to the fixed trash container on the deck, multichannel pipettes crash against the edge of the fixed trash.
## current behavior
When dispensing to trash using a mul…
-
# 公式错误 P300
- [ ] 公式错误：P300 公式12.37 上方“先证明p(vi = 1|h)”改为“先证明p(hi = 1|v)”