-
### Version
Version 2.3.3.+x64
_Use `About->About PrusaSlicer` for release versions_
### Operating system type + version
MAC OS Version 11.4
### 3D printer brand / version + firmware…
-
Hi there, I am new here
I would like to know if I would like to keep entries in VCF to a specific set of filters.
For example, I would accept variants with any combinations of the following filters:…
-
Using the A350, when starting each 3d print job, the nozzle does not attempt to heat until the bed reaches the desired temperature. This is inefficient. I realize it takes a long time for the bed to r…
-
I have tuned PID for hot-end and bed with MK4DUE works pretty fine, for hot-end deviation is about +/-0.2 C, for bed it is less then 0.1 C. But with Klipper with same PID settings I have +/- 2 C for h…
St007 updated
2 years ago
-
Hi, im running valetudo 0.3.1 and today robo was not accessable, so i restarted the robot and after that he was back with default AP. No ssh connection possible und no valetudo available at port 80.
…
xoxys updated
2 years ago
-
I used miio to retrieve all of my rooms via get_room_mapping. I do not need to use zone coordinates to define my rooms.
Can this card be updated to make use of these for room numbers in addition?
-
When entering MON for the county in the FQP, it shows up a MT (Montana the state). I suspect this is because the florida.dom file has INCLUDE FILE S50.DOM as the first DOM referenced. That brings in t…
-
Valetudo worked properly on older firmware but now returns error 500 when using map function on Gen 1 firmware v11_003514 (downloaded via FloleVac app).
-
## Description
Generate a report showing all queries between (May 13-May 31) that had zero typeahead suggestions generated.
## Tasks
- [x] Sam to generate report
- [x] Denise to manual rev…
-
Background:
I have a large biochemical reaction network model on which I am trying to run some benchmarks on. When I try to load it as a ReactioSystem and evaluate the problem function, Julai crashes…