-
Hey Guys,
I’m just a beginner with Arduino and what I’m trying to do is take an incoming audio signal and then transmitted through a Bluetooth dongle. The Bluetooth dongle that I’m using for this i…
-
Hi Sven,
I encountered a problem with the S command in a nc file an GRBL-Plotter.
Acording the S command in the nc file the spindle should work with 15000 rpm,
but it turned only with the min rpm…
-
Hi Sven,
I'm more or less sure that my Joystick issues commands to the serial port.
Only there is no visible reaction in GRBL-Plotter.
The stylus doesn't move, the coordinates do not change.
Can…
-
Hi Kris!
I am honestly tired due to 5 days and night of straight browsing, reading and basically doing anything to calibrate my MPU9250, I have read the 0x73 "issue" and that my sensor is MPU9255, I …
-
Can't open directly from Launchpad on macOS, but can start in Terminal.
macOS version: 10.14.2 (18C54)
```
2019-01-18 11:18:28,589 - root:95(excepthook) ERROR: Unrecoverable error
Traceback (most …
-
To reproduce
connect to a serial connection that sends plotter data.
Turn hide plotter data on/off/on and the plotter data will still be visible.
-
Hi Sven,
This is not a big issue since your current implementation works, but I wanted to point it out.
You recently pointed me to the instructions for GRBL communication and we got through all …
-
I am making a remote heart rate monitor to send BPM to an android phone. The android part works correctly. However, the BPM fails to go back to zero after I remove the finger. With the finger placed …
-
The code:
```
/*
AnalogReadSerial
Reads an analog input on pin 0, prints the result to the Serial Monitor.
Graphical representation is available using Serial Plotter (Tools > Serial Plott…
-
Greetings,
I have encountered a rather strange issue while using two sensors and was hoping for some help. The two sensors of which I speak are as follows:
1) a Galvanic skin response sensor (m…