-
**Home Assistant release with the issue:** 0.92.x
**Last working Home Assistant release (if known):** 0.91.x
**Operating environment (Hass.io/Docker/Windows/etc.):** Centos 7 Pip
…
-
Hi Theo,
can tasmota get support for Shelly 2?
https://shelly.cloud/shelly2/
Shelly 2 is very small wifi device with 2 relays, power meter and should also use ESP8266.
In most cases, it fits in …
h-tro updated
5 years ago
-
**Home Assistant release with the issue:**
0.75.3
**Last working Home Assistant release (if known):**
0.72
**Operating environment (Hass.io/Docker/Windows/etc.):**
hassbian rele…
-
Where can I set this "minimum interval" in the Source Code?
The actual minimum of 10 seconds is too long for my project.
EDIT: And I would also like to know, where to change the resolution of the "d…
lev2k updated
6 years ago
-
This is not an issue with the code, but to highlight a point. I noticed that a lot of the “issues” here are not really issues and that they are just requests for help. After speaking with Theo, we dec…
ghost updated
6 years ago
-
i got a POW with 6.1.1 running for my heatpump. the heatpump got an inverter and is very easy on the current side. it ramps up very slowly, and it takes about 5-10min until it reaches full speed and t…
-
Module Type: Generic
One Relay1 and two Switches - Switch1(Button), Switch8(HC-SR501 - Pir sensor)
Options: SwitchTopic 1, SwitchMode8 1
MQTT Library: MQTT_TASMOTAMQTT
When MQTT Server is unavai…
-
## Mycodo Issue Report:
- Specific Mycodo Version: 6.4.5
#### Problem Description
Setup conditional measurement control to turn on a relay. Conditional control stops working after some time. …
-
It took me quiet a while to figure this out as I'm new to hass and I wasn't sure I had the templates right at first, but every time I restart hass (either via Configuration -> General -> Restart) or b…
-
I made the following setup:
with a nodemcu controlling all the relays. They work in …