-
: Gtk-WARNING **: 19:16:49.522: Negative content height -1 (allocation 1,…
-
Hi
I tested P2.5(128x64) RGB Panel with stm32F103RCT6 72Mhz and blackpill stm32F411CE 100Mhz
stm32F411CE with 1 panel(128x64) or 2 panels (128x128) without Noise and Flickering , Correct Color…
-
Hello!
```
./wchisp info
10:26:21 [INFO] Found USB Device Bus 001 Device 018: ID 4348:55e0
10:26:21 [DEBUG] (1) wchisp::transport: => a11200 00004d4355204953502026205743482e434e
10:26:21 [DEB…
-
Would it be possible to add an audible warning, like the low battery beep tone, when the transmission error rate is too high?
-
I started a compatibility list, all tests with the OIT core. Keep in mind i only played them a few minutes (there could be more issues in late game).
Non-MAME dump are deprecated, don't report issue …
-
Printing from Octoprint frequently finds an extruder switch at random, uncommanded. The forum also reports this problem on any USB connection, not just Octoprint. I'm currently testing this from the…
-
Hi
Is it possible to support, 64 pin STM32F103RC with 256 Kbytes of Flash memory? so I want to use BTT SKR MINI E3 V2.0 3D printer board.
https://www.bigtree-tech.com/products/bigtreetech-skr-mini-e…
-
## Describe the Bug
Flashing Preonic/rev3 with default or custom keymaps succeeds but the keyboard is unresponsive and emitting a monotone continuous sound (instead of the standard three-tone conne…
-
Hi,
fresh install with device attached to an RasperryPi 400 give this result below, I would like to report the
KERNELHEADERS_DIR-NOTFOUND when compiling module smi_stream_dev.ko and the missing …